AC Runs but Won’t Cool? 7 Things to Check Before You Call

Technician checking refrigerant pressures on an AC that runs but won't cool

Your AC runs but won’t cool: the fan is running, the outdoor unit is humming, and the house is still warm. Before you book a repair, these checks can save you a service call. Turn the system off at the thermostat before touching anything.

1. Check the thermostat

Make sure it’s set to Cool, the setpoint is below room temperature, and the fan is on Auto, not On. With the fan on “On”, the blower keeps running between cycles and can blow warm air. Replace the batteries if the screen is dim or blank.

2. Replace the air filter

A clogged filter chokes airflow. The coil can freeze and cooling drops. Swap it if you can’t see light through it.

A yearly AC maintenance visit includes a filter and coil check. See ENERGY STAR’s heating and cooling tips.

3. Look at the outdoor unit

Is the fan spinning? Clear leaves, grass clippings and cottonwood away from the coil, at least two feet on all sides. Gently rinse the fins with a garden hose (no pressure washer) with the power off.

4. Check the breakers

An AC can have two breakers, one for the indoor blower and one for the outdoor unit. If the outdoor breaker tripped, reset it once. If it trips again, stop and call us.

5. Look for ice

Ice on the refrigerant lines or indoor coil usually means low airflow or low refrigerant. Turn cooling off, set the fan to On for a few hours to thaw it, and replace the filter. If it ices again, call a technician.

6. Check the vents

Make sure supply registers are open and return grilles aren’t blocked by furniture.

7. Check the condensate drain

Many systems have a float switch that shuts off cooling when the drain pan fills. Look (don’t take anything apart): is there water standing in the pan under the indoor unit, or pooling on the floor around it? If so, the drain is likely clogged and the switch has tripped. Don’t try to clear the line yourself. Call us and we’ll clear it and check the switch.

When an AC that won’t cool needs a pro

Call us if:

  • the outdoor fan isn’t spinning, or the unit hums but doesn’t start,
  • the breaker trips more than once,
  • the coil keeps icing up,
  • you hear grinding, screeching, or clicking, or
  • you smell burning.

These usually point to a failed capacitor, contactor, fan motor, refrigerant leak, or compressor problem. Those need a licensed technician and the right tools. Don’t add refrigerant yourself.

If the system is older and the compressor has failed, replacement may be the better value. See AC replacement in Bolingbrook and our AC installation cost guide.

What a repair visit costs

Repair visits have a diagnostic fee. The technician finds the cause, explains it, and gives you a written price before any work. If the system is older and a major part has failed, we’ll explain your options, including replacement, and estimates on replacements are free.

We serve Bolingbrook, Naperville, Lemont and nearby suburbs.

Open 24/7: call or book anytime. Office staffed Mon–Fri 7:30 AM–6 PM. Call (312) 500-4822. Same-day and emergency service when available.

Q&A

Why is my AC blowing warm air?

Common causes are a thermostat set to fan “On”, a dirty filter, a tripped outdoor breaker, a frozen coil, or low refrigerant.

Can low refrigerant fix itself?

No. Refrigerant doesn’t get used up. Low refrigerant means a leak that needs to be found and repaired.

How long should my AC take to cool the house?

It depends on the home, the weather and the system size. If the temperature isn’t dropping at all after an hour or so with the checks above done, call us.

Is it safe to keep running my AC if it’s not cooling?

If it’s icing up or making unusual noise, turn it off to avoid damaging the compressor, and call for service.